Surround Speakers; Connecting Other Equipment; Adjusting The Voltage Selector; Cancelling The Display Demonstration - JVC CA-MXSK1 Instructions Manual

Surround Speakers

For Model CA-MXSK3
To connect surround speakers.
SURROUND SPEAKERS
CAUTION:
SPEAKER IMPEDANCE
16 ~ 32 Ω
• Connect the right rear speaker to the RIGHT jack.
• Connect the left rear speaker to the LEFT jack.
How to install Surround Speakers
• This equipment is not magnet-proof. If it is placed near a
TV set, color on a TV screen may become uneven.
Therefore, when installing, locate the speaker at sufficient
distance away from the TV set.
• When setting the speaker on a high shelf, be sure to fix
them to the shelf by using metal braces: this is a precaution
to avoid the speakers from falling off due to shelf
trembling.
CAUTION:
The speakers are designed to be attached on the wall. Please
have the qualified personnel to attach the speakers on the wall.
DO NOT hang the speakers by yourself to avoid the unexpected
danger whereby the speakers fall off due to incorrect attachment
or unstable wall.

Connecting Other Equipment

You can connect both analog and digital equipment.
• DO NOT connect any equipment while the power
is on.
• DO NOT plug in any equipment until all
connections are complete.
To connect an analog component
Be sure that the plugs of the audio cords are coloured: White
plugs and jacks are for left audio signals, and red ones for
right audio signals.
To audio output
For playing the other equipment through this unit,
connect between the audio output jacks on the other
equipment and AUX jacks by using audio cords (not
supplied).
AUX
IN
Audio equipment

Adjusting the Voltage Selector

Before plugging in the unit, set the correct voltage for your
area with the voltage selector on the rear of the unit.
Voltage mark
Use a screwdriver to rotate the voltage selector so the voltage
number the voltage mark is pointing at is the same as the
voltage where you are plugging in the unit. (See the back
cover page.)
DO NOT plug in before setting the voltage selector
on the rear of the unit and all connection
procedures are complete.
Now, you can plug in the AC power cord.
When connecting the AC power cord to a wall outlet, the unit
automatically starts display demonstration.
• If the wall outlet does not match the AC plug, use the
supplied AC plug adaptor.
IMPORTANT: Be sure to check all connections to be done
before plugging the AC power cord into a wall outlet.

Cancelling the Display Demonstration

On the unit ONLY:
To cancel the display demonstration, press
CANCEL/DEMO during demonstration,
"DEMO OFF" will appear on the display.
When you press other buttons
The display demonstration stops temporarily. It will start
automatically again (if no operation is done for 2 minutes) unless
you cancel it by pressing CANCEL/DEMO.
To start the display demonstration manually
Press and hold CANCEL/DEMO again for more than 3
seconds.
– 8 –
110V
127V
220V
230V-240V