Recording; Recording A Tape On Deck B - JVC CA-MXSK1 Instructions Manual

Recording

IMPORTANT:
• It may be unlawful to record or play back copyrighted
material without the consent of the copyright owner.
• The recording level is automatically set correctly, so it is
not affected by the VOLUME, the ACTIVE BASS EX., the
SOUND TURBO, and the SOUND MODE. Thus, during
recording you can adjust the sound you are actually
listening to without affecting the recording level.
• If recordings you have made have excessive noise or static,
the unit may be too close to a TV. Increase the distance
between the TV and the unit.
• You can use type I tape for recording.
To protect your recording
Cassettes have two small
tabs on the back to protect
from accidental erasure or
re-recording.
To protect your recording,
remove these tabs.
To re-record on a protected tape, cover the holes with
adhesive tape.
To keep the best recording and playback sound quality
If the heads, capstans, and pinch rollers of the cassette decks
become dirty, the following will occur:
• Impaired sound quality
• Discontinuous sound
• Fading
• Incomplete erasure
• Difficulty in recording
To clean the heads, capstans, and pinch rollers
Use a cotton swab moistened with alcohol.
Pinch rollers
Capstans
Heads
To demagnetize the heads
Turn off the unit, and use a head demagnetizer (available at
electronics and audio shops).

Recording a Tape on Deck B

1
Press EJECT 0 for deck B.
2
Put a recordable cassette into deck B.
3
Close the cassette holder gently.
4
Check the tape direction of deck B.
• If the tape direction is not correct, press TAPE–B 2 3
twice then 7 to change the tape direction.
5
Start playing the source — FM, AM, CD
player, deck A or auxiliary equipment
connected to AUX jacks.
• When the source is CD, you can also use CD Direct
Recording (see page 25).
• When the source is deck A, you can also use the
dubbing method. (See "Dubbing Tapes" on page 25 .)
6
Start recording.
Press REC START/STOP.
The (recording) indicator lights up on the
display and recording starts.
• If no cassette is inserted, "NO TAPE" appears
on the display. If a protected tape is inserted,
"NO REC" appears on the display.
To stop recording immediately, press 7.
To remove the cassette, press EJECT 0 for deck B.
REC START/STOP
During CD mode, when recording stop after tape finish,
press 7 once to cancel the recording function. Otherwise, the
system will remain in recording mode and certain operations
will be invalid.
– 24 –