Oyster Vision III Operating Instructions Manual page 6

Safety instructions
Note on Safety - Oyster Vision III
Stop function via the control device and the remove of the power sup-
ply during maintenance.
Press the Selection button
vement of the antenna. In this stop mode no receiver DiSEqC control commands are
executed more.
To abolished the stop function scroll via
Search" and pressing the Selection button
, which causes that enters the antenna.
During maintenance on the antenna system it is essential, that the operating volta-
ge of the complete system, receiver and VISION III control box, are off.
If the system is reconnected to power, the display of the control panel „activate".
Only after pressing the On / Off button
extend again. Please note that commercial receivers depending on the type can take
up to 90 seconds to initialize.
on the keypad on the control device to stop the mo-
. Or by press the the On / Off button
on the control panel, the antenna can
6
on the keypad to select „Auto