Receiver Control - Oyster Vision III Operating Instructions Manual

Receiver control

Access via level 1 „Main menu"
Receiver control: With this menu option you can confi gure the optional settings
for the system control by the receiver. By selecting the mode, you can determine if
and how the system is started by the receiver.
Mode 1 „Auto off" (default setting)
This mode is recommended for receivers that never switch off the LNB
voltage, or if you wish that the receiver shall not control the antenna.
The system can then be switched on and off only at the Sat button of the
control device.
Mode 2 „Auto Stby"
This mode is recommended if the LNB voltage is switched off when the
receiver is in standby mode.
The system can be switched on and off via the satellite receiver and at the
Sat button of the control device.
The receiver is switched on. Depending on the model, a receiver may need
up to three minutes to boot. The antenna will open only after this boot
period to search for the satellite.
The receiver is switched off: The antenna closes and switches into standby
mode.
Mode 3 „Auto Sleep"
This mode is recommended if the receiver does not provide voltage to the LNB
when in standby mode.
The system can be switched on and off via the satellite receiver and at the
Sat button of the control device.
The receiver is switched on: If the antenna was closed, it will open and
search for the satellite selected. If the antenna was already open, it will
remain in this position. If no signal is received in this position, the system
will search for the satellite selected.
The receiver is switched off: The system switches into standby mode with
the antenna remaining in its current position (sleep mode).
In „Auto Sleep" mode the antenna can be closed by pressing the Sat button
of the control device.
and and „Settings"
15