Sat Mode; Entering The Position; Manual Search - Oyster Vision III Operating Instructions Manual

SAT mode

SAT mode

Entering the position

„Entering the position" is a selectable option of the main menu. Press
a list of countries, and use the buttons
lect your location. This speeds up the satellite search.
The antenna is then optimally adjusted for the satellite search from your current
position (LNB and inclination angle).
Manual satellite search
The manual search is usually used to fi ne-tune the antenna to a found satellite in
case of adverse reception conditions.
If you wish to receive signals from a new satellite that is not yet stored as a search
satellite in the control unit, the manual search function can be used to tune the
system to this satellite.
Firstly, switch your receiver to a preset station that is transmitted by the satellite
selected.
At the control device, press
„Manual search" appears in the display.
Programming sequence for function Manual search:
Level 1

Manual search

Press to access sub-level A
and select an option.
Note:
Press the sat button
back one level.
This display indicates that the system is in signal reception mode.
Press to display the currently received satellite.
repeatedly until the message
Sub-level A
Press
option.
to go
to scroll the list and use
or to select an
12
to access
Sub-level B
Press or to edit the
option.
to se-