Oyster Vision III Operating Instructions Manual page 19

Satellite settings / DiSEqC: on / off
Satellites are changed using the receiver's DiSEqC signals. The signals or the
DiSEqC ID of the receiver must comply with the ID list saved in the control unit of
your Vision system.
16 satellites with a DiSEqC ID number are preset in your Vision system
(see table).
The DiSEqC function is active when the DiSEqC option has been enabled or if
„DiSEqC" is set to On with the Vision III control unit being on!
No. Satellite name
1 Astra 1
2 Astra 2
3 Astra 3
4 HotBird
5 Eutelsat 5 West
6 Thor/Intel 10-02
7 Astra 4
8 Eutelsat 16
9 Eutelsat 7
10 Amos 2/3
11 Hispasat
12 Telstar 12
13 Eutelsat 9
14 Eutelsat 33
15 Hellas Sat 2
16 Türksat 2/3
Here you can adopt the default settings of the Vision system into your satellite
receiver. Please refer to the manual of your receiver.
Important:
Further DiSEqC functions (DiSEqC V3-ID, DiSEqC Rec-ID, DiSEqC Data) are only
accessible if „DiSEqC: on/off" is set to „on" !
DiSEqC ID
19.2° East 1
28.2° East 5
23.5° East 3
13.0° East 2
5.0° West 4
1.0° West 7
5.0° East 6
16.0° East 15
7.0° East 9
4.0° West 13
30.0° West 21
15.0° West 17
9.0° East 18
33.0° East 24
39.0° East 10
42.0° East 11
19