Table of Contents
Advertisement
H
S
OW TO
ET
HOW TO MOVE AND LEVEL THE RECUMBENT
BIKE
Before moving the recumbent bike, make sure
that the power cord is unplugged. Note: If a CATV
cable is connected to the recumbent bike, it may be
necessary to disconnect the cable if the recumbent
bike will be moved far.
Due to the size and weight of the recumbent bike,
moving it requires two persons. While one person
lifts the indicated end, firmly hold the handlebar and
tip the recumbent bike forward until it rolls on the
front wheels. Carefully move the recumbent bike to
the desired location and then lower it back to the
level position. CAUTION: To reduce the risk of in-
jury, use extreme caution while moving the re-
cumbent bike. Do not attempt to move the re-
cumbent bike over uneven surfaces.
If the recumbent bike rocks slightly during use, turn
the leveling feet under the rear of the frame until the
rocking motion is eliminated.
HOW TO ADJUST THE SEAT
To adjust the seat, lift the seat latch, slide the seat
forward or backward to the desired position, and then
push the seat latch back down.
HOW TO CONNECT THE POWER CORD
If the recumbent bike has a Basic console, it can be used with or
without the included power cord. If the recumbent bike has a
Workout TV console, the power cord must be used for the TV to be
operated.
To use the power cord, first plug one end of the power cord into the
jack on the front of the recumbent bike. Plug the other end of the
power cord into an appropriate outlet that is properly installed in ac-
cordance with all local codes and ordinances.
U
R
P THE
ECUMBENT
B
IKE
Lift
Here
Wheels
Power
Cord
Jack
7
Handlebar
Leveling
Feet
Seat
Latch
Advertisement
Table of Contents
