Pressure Washers and Accessories COBALT SERIES PRESSURE WASHERS Operators Manual Delco Pressure Washers - LIT-COB-DEL...
Page 2
Should you experience any difficulty with your Delco pressure washer, please contact your nearest Delco Distributor immediately. We are aware of your investment in an Delco pressure washer, therefore, our prime concern is that you be- come one of our “satisfied” owners. Please feel free to send us your comments and ideas.
Page 3
Pressure Washer Limited Warranty 1. DELCO Cleaning Systems, LLC warrants its products for a period of one year from the date of pur- chase, against defects in material and/or workmanship. The warranty covers parts and labor, but ex- cludes transportation.
IMPORTANT SAFETY PRECAUTIONS IMPORTANT: Please read the following instructions before installing and operating this equipment. DANGER THIS EQUIPMENT CAN BE HAZARDOUS TO OPERATOR SAFETY AND ONLY AUTHORIZED PERSON- NEL WHO HAVE READ AND UNDERSTAND THE INSTALLATION AND OPERATION MANUAL SHOULD BE PERMITTED TO OPERATE THIS EQUIPMENT.
Page 5
DO NOT’S DO NOT - UNDER ANY CIRCUMSTANCES - POINT THE HIGH PRESSURE NOZZLE AT YOURSELF, OTHER PEOPLE, OR ANIMALS! 1. DO NOT use an undersized discharge nozzle. 2. DO NOT disconnect the pressure hoses or wand while the equipment is HOT, PRESSURIZED or RUN- NING.
OPERATING THE MACHINE PRE-OPERATING INSTRUCTIONS - 1. Connect the power cord to an adequately wired and grounded electrical source (115V or 230V depend- ing on model). 2. Check pump oil level and fill if necessary. 3. Turn the water source on. If leaks are detected, check hoses, fittings and check or replace o-rings. 4.
MAINTENANCE OF COMPONENTS THINGS TO CHECK DAILY - 1. Check oil level in pump. 2. Fill soap container (If applicable). THINGS TO CHECK WEEKLY - 1. Check all hoses for leaks and damage. Repair or replace as needed. 2. Check cleaning nozzles for wear. Replace if needed. 4.
DIAGNOSIS AND MAINTENANCE PROBLEM PROBABLE CAUSE SOLUTION Low Pressure Worn nozzle Replace nozzle of proper size. Belt slippage. Tighten or replace; use correct belt. Air leak in inlet plumbing. Use PTFE liquid or tape. Pressure gauge inoperative or not Check pressure with new guage and replace as needed. registering accurately.
Page 10
1111 E. Lake Francis Dr., Siloam Springs, AR 72761 • 800-BUY-DELCO...
Need help?
Do you have a question about the COBALT SERIES and is the answer not in the manual?
Questions and answers