Using Daily Timer - JVC CA-HXZ55D Instructions Manual

There are three timers available—DAILY (Daily Timer), REC
(Recording Timer), and SLEEP (Sleep Timer).
• Before using the timers, set the clock built in the unit. (See page
13.)

Using Daily Timer

With Daily Timer, you can wake up to your favorite music or radio
program.
• You can set the timers whether the unit is on or off.
How Daily Timer actually works
The unit automatically turns on, sets the volume level to the preset
level, and starts playing the specified source when the on-time
comes. ("DAILY" and the DAILY indicator on the display flash just
before the on-time. The DAILY indicator continues flashing while
the timer is operating.) Then, when the off-time comes ("DAILY
OFF" appears on the display just before the off-time), the unit
automatically turns off (standby).
The Daily Timer works everyday automatically. If you do not want
to use the Daily Timer, turn it off. (See "To turn on or off Daily
Timer" on page 55.) The timer setting remains in memory until you
change it.
• There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
• To correct a misentry while setting the timer, press CANCEL/
DEMO.
Before you start...
• When using a disc as the source to play:
– Make sure there is a disc on the selected disc tray.
– The Daily Timer cannot be able to use with JPEG discs.
• When using a tape as the source to play:
– Make sure that a tape is in the cassette deck.
– Make sure that the tape direction is correct.
• When using an external component as the source to play:
– Set the timer equipped on the external component to the
same time.
On the front panel ONLY:
1
Press CLOCK/TIMER repeatedly until
"DAILY" appears on the display.
The (Timer) indicator lights up and the DAILY (Daily Timer)
indicator starts flashing.
• Each time you press the button, the timer setting modes
change as follows:
DAILY TIMER
(Daily Timer setting)
(Daily Timer on/off)
Canceled
(The hour digits start flashing.)
REC
(Recording Timer on/off)
Clock
TIMER
setting
(Recording Timer setting)
2
Press CLOCK/TIMER again.
"TIMER" appears for about 2 seconds, then the unit enters on-
time setting mode.
3
Set the on-time you want the unit to turn on at.
(1) Turn ¢ / 4 to set the hour, then press SET/DISPLAY.
(2) Turn ¢ / 4 to set the minute, then press SET/DISPLAY.
"SET" appears for about 1 second, then the unit enters off-
time setting mode.
4
Set the off-time you want the unit to turn off
(standby) at.
(1) Turn ¢ / 4 to set the hour, then press SET/DISPLAY.
(2) Turn ¢ / 4 to set the minute, then press SET/DISPLAY.
"SET" appears for about 1 second, then the unit enters
source selecting mode.
5
Turn ¢ / 4 to select the source to play, then
press SET/DISPLAY.
"SET" appears for about 1 second.
• As you turn ¢ / 4, the source changes as follows:
DISC TAPE
TUNER AM
DISC: plays a disc from a track/chapter of a group/
title on specified disc.
= Go to step 6 .
TAPE: plays a tape in the cassette deck.
= Go to step 7 .
AUX IN:
plays an external source.
= Go to step 7 .
TUNER FM: tunes in to a specified preset FM station.
= Go to step 6 .
TUNER AM:
tunes in to a specified preset AM station.
= Go to step 6 .
AUX IN
TUNER FM
54