Alarm Function - JVC CA-D452TR Instructions Manual

or
– SELECT +
or
PTY/EON
16
2. Select information you want by pressing SELECT + or SELECT –.
• When using the Remote Control, press the 9 SELECT + or 8 SELECT – button.
TA: Identifies that a traffic announcement is being broadcast in your area.
NEWS:
News
INFO: Programmes on medical service, weather forecast, etc.
• Each time you press the button, EON codes change as follows:
SELECT + =
Ô TAÔ NEWS Ô INFO Ô OFF Ô
+ SELECT –
3. Press PTY/EON.
• When using the Remote Control, press 3 PTY/EON.
As soon as your selection is entered, the Unit will go into EON Standby reception mode.
To cancel the EON function, select "OFF" by following the steps above.
When this Unit carries out EON Standby reception, the indication will
change as follows:
1. Waiting for EON Standby reception.
2. Preset stations are being searched for and while preparing to change the station, sound will be muted.
3. The station will be changed and the Station name being received will appear on the display.
• To view the other RDS information on the display, press DISPLAY MODE. (When using the
Remote Control, press 6 DISPLAY MODE after pressing RDS CONTROL).
Notes:
• EON broadcasts of some stations may not be compatible with this Unit. In the case of an incompatible
EON broadcast, "EON" will not appear on the display.
• If the reception is unsatisfactory for a station among the preset stations, the station is searched for
again. If after searching through the channels, the broadcasting station cannot be found,
"NOTFOUND" appears on the display. The Unit will return to the station to which it was previously
tuned.
When broadcasting of the desired information has been completed, the Unit will automatically go back to
the station which had previously been tuned to.
While receiving information on EON Standby reception, the station will not change to other stations
even if the same information is available from them.
If the information you are waiting for is available from the current station, the indicator will flash.
ALARM function ——————————————————————
If an ALARM (Emergency) signal is received while receiving an EON code from a station, the Unit
automatically switches to the station broadcasting the ALARM signal.
Light up
(Station name)
Flashing