Standard Recording - JVC CA-D452TR Instructions Manual

REC PAUSE
TAPE
CONTROL \
CAUTION: If recordings you have made have excessive noise or static,
the Unit may be too close to a TV which was on during recording. Either
turn off the TV or increase the distance between the TV and the System.

Standard Recording

This is the basic method for recording any source. The System also has special ways for recording CD to
tape, and tape to tape, which save your time and effort, as well as give you some special effects. However,
when you need to add a selection to a tape you have made, or are combining selections from several
sources on one tape, use the method described below; just substitute the source you want into this
procedure, such as a CD or the Tuner. You can also record from auxiliary source with this procedure.
Using the Unit
1. Insert a blank or erasable tape into Deck B.
2. Press REVERSE MODE if you want to record on both sides of the
tape.
Reverse Mode comes on.
• When using Reverse Mode, insert the tape so that it will be recorded in the forward (3) direction.
3. Check the recording direction for the tape.
Check that the Tape Direction indicator is the same as that for the tape in the tape deck. If the
directions are different, press 7 STOP after pressing TAPE ™ £ to set the tape direction.
• When using the Reverse Mode to record both sides of a tape, check that the Tape Direction
indicator is in the forward (3) direction. If the direction indicator is not in the forward (3)
direction, press TAPE ™ £ then press 7 STOP.
4. Prepare the source, for example, by tuning in a radio station,
loading CDs, or turning on connected equipment.
5. Press REC START/STOP.
The REC indicator lights up and the System begins recording.
Using the Remote Control
1. Insert a blank or erasable tape into Deck B.
2. Press REVERSE MODE on the Unit if you want to record on both
sides of the tape.
Reverse Mode comes on.
• When using Reverse Mode, insert the tape so that it will be recorded in the forward (3) direction.
3. Prepare the source, for example, by tuning in a radio station,
loading CDs, or turning on connected equipment.
4. Press REC PAUSE.
The REC indicator starts flashing.
5. Press TAPE CONTROL then press 3.
Recording starts.
The REC indicator stops flashing and remains lit.
Notes for using Reverse Mode for recording
When recording with Reverse Mode on, the System automatically stops when it reaches the end of the
reverse (2) direction. To record on both sides of a tape, make sure that the recording direction for the tape
inserted into Deck B is forward (3), and that the Tape Direction indicator is also forward (3), before you
start recording.
To pause at any time during the recording process
Press REC PAUSE on the Remote Control. Then press 3 on the Remote Control or REC START/STOP
on the Unit to restart recording.
To stop at any time during the recording process
Press REC START/STOP on the Unit again, or press 7 on the Remote Control.
27