Figure 50 - Restore Configuration File Pop Up Screen - Motorola PTP 300 Series User Manual

CAUTION
The configuration file is currently restricted to a single software version and can only
be restored into a wireless unit operating the software version indicated in the
configuration file header.
7.5.4.2 Restore Configuration File
The configuration file can also be used when swapping out a faulty wireless unit. If one of the
wireless units is replaced on a wireless link a configuration file captured from the faulty unit
can be uploaded into the new unit to speed up replacement.
NOTE
The license key of the faulty unit should be setup on the replacement unit before the
configuration file is loaded. This can be obtained either from the Deployment Guide
supplied with the faulty wireless unit or directly from Motorola. The target MAC
address at the other end needs to be changed to ensure that it is using the MAC
address of the replaced unit.
The restoration of configuration files can be performed using the Restore configuration tool.
Using the browser button to locate the configuration file you wish to restore then click the
'Restore Configuration File and Reboot' button (Figure 50). The user will then be prompted to
confirm the action (Figure 51).
4Gon www.4Gon.co.uk info@4gon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299

Figure 50 - Restore Configuration File Pop Up Screen

95
7 Web Page Reference