Check Of The Supply; Outboard Motor Mounting - SELVA MARINE Corse Owner's Manual

Check of the supply.

When you receive your motor, check that:
- the packing is integral
- the supply corresponds to the detailed list:
the entire motor
1.
tool-bag
2.
use and maintenance manual
3.
certificate of guarantee
4.
list of our dealers and our after-sales service
5.
registration book (only for the Italian market)
6.
declaration of conformity
7. CE
- that there is no evident damage. If there is a damage or if
parts are missing, you must inform immediately and in detail
the forwarding- agent, SELVA joint-stock CO. or its area
agents.
Check that the registration book, the certificate of
guarantee and the CE declaration conformity are
duly filled in and signed, and that the data written in
them correspond to the data printed on the engine's
label.
c

Outboard motor mounting

very important to have an appropriate trim angle and therefore
to obtain a good performance from your boat
To have the optimum mounting height of the outboard motor,
you must mount it so that the anti-cavitation plate is between
the bottom of the boat and a level of 2 cm below it and it is
parallel to it.
Picture No. 30.
13
A good position of the motor on the transom is
If the mounting-height is too high, cavitation tends to
occur and consequently there will be a falling-off in
the performance and a probable overheating of the
motor. If the mounting-height is too low, the water-
resistance will increase and thereby reduce engine
efficiency.
The motor must be vertical to the water surface and
the bracket mounted on a flat even surface and
should be fully supported by the top edge of the
transom.
If the bracket is not fully supported or, if the transom
height is too low, a hard wood block should be
securely fitted between the bracket and the transom
Fix the engine in the correct position locking the
clamp screws.
Picture No. 31.
Picture No. 32.
Picture No. 33.