Connect The Piping - Panasonic CS-S18JKQ Service Manual

10.2.3.3 For the embedded piping
Replace the drain hose
Bend the embedded piping
Pull the connecting cable into indoor unit
Cut and flare the embedded piping
Install the Indoor Unit

Connect the piping

Insulate and finish the piping
Secure the Indoor Unit
(This can be used for left rear piping & left bottom piping also.)
Replace the drain hose
Rear view for left piping installation
Drain hose
Drain cap
How to pull the piping and drain hose out, in
case of the embedded piping
Apply putty or
caulking material
to seal the wall
opening.
PVC tube for
drain hose (VP-20)
Connecting
cable
Adjust the piping slightly downwards.
Connecting
cable
Piping
Drain hose
from main unit
PVC tube (VP-65) for piping
and connecting cable
PVC tube for drain hose (VP-30)
•
Use a spring bender or equivalent to bend the
piping so that the piping is not crushed.
•
The inside and outside connecting cable can be
connected without removing the front grille.
•
When determining the dimensions of the piping, slide the
unit all the way to the left on the installation plate.
•
Refer to the section "Cutting and flaring the piping".
•
Please refer to "Connecting the piping" column in the
outdoor unit section (Below steps are done after connecting
the outdoor piping and gas-leakage confirmation
•
Please refer to "Piping and finishing" column in the outdoor
section and "Insulation of piping connections" column as
mentioned in Indoor/Outdoor unit installation.
Drain hose
PVC tube Cable
for drain
hose
Piping
Indoor unit
72 mm
22
Connectin g
cable
Piping
More than
Drain hose
1150 mm
Sleeve for piping hole
In case of left piping how to insert
the connecting cable and drain
hose.
Drain
hose
Cable
Piping
(For the right piping, follow the
same procedure)