Indoor Unit Installation - Panasonic CS-S18JKQ Service Manual

10.2.3 Indoor Unit Installation

10.2.3.1 For the right rear piping
Pull out the Indoor Piping
Install the Indoor Unit
Secure the Indoor Unit
Insert the Connecting Cable
10.2.3.2 For the right and right bottom piping
Pull out the Indoor Piping
Install the Indoor Unit
Insert the connecting cable
Secure the indoor unit
Right Rear piping
Tape it with piping in a
position as mentione d
in Fig. belo w .
Piping
Coverfor
Drainhose
the right
piping
How to keep the cover
In case of the cover is cut,
keep the cover at the rear of
chassis as shown in the
illustration for future
reinstallation.
(Left, right and 2 bottom
covers for piping.)
Secure the Indoor Unit
1. Power supply cord arrangement
Excess length of power supply cord should be arranged
behind the chassis at piping keeping area as shown in the
diagram without tying up in a bundle.
Ensure that the power supply cord is not clamped in
between unit's hook (2 position) and installation plate.
Ensure that the power supply cord is not stretched between
chassis back and installation plate. It may create squeak
sound.
Do not tie up power supply
cord into a bundle by band. It
may generate heat and cause
fire.
Power supply cord
Caution
!
Do not turn over the unit without it 's shock
absorber during pull out the piping. It may
cause intake grille damage
Piping
Intake grille
Right and Right Bottom piping
Tapeit with piping in a
position as mentionedin
Fig. below
Coverfor
Cover for the
the left
bottompiping
piping
Drain hose
Install the indoor unit
Hook the indoor unit onto
Cover for piping
the upper portion of
installation plate. (Engage
the indoor unit with the
upper edge of the
installation plate). Ensure
the hooks are properly
seated on the installation
plate by moving it in left
and right.
Press the lower left and right
side of the unit against the
installation plate until hooks
engages with their slot (sound
click).
Warning
!
If indoor power supply, excess length of power
supply must arrange accordingly, please refer
"Power supply cord arrangement" before secure
the indoor unit
If indoor power supply, excess length of power
supply must arrange accordingly, please refer
"Power supply cord arrangement: before secure
the indoor unit.
Piping
Coverfor
Cover for the
Cover for the left
bottom piping
the right piping
piping
Hooks at
installation
plate
Sleevefor
piping hole
Indoo r unit
Drain hose
Installation
Unit's
plate
hoo k
21
• Use shock absorber during pull out
the piping to protect the intake grille
from damage.
Piping
Shock absorber
Insert the connecting cable
Guide
Conne cting cable
surface
Piping
Marking
To take out the unit, push the
bottom unit, and pull it slightly towards you to
disengage the hooks from the unit.
Conne cting
cable
Gas side
piping
Liquid side
piping
Drain hose
marking at the