Table of Contents
Advertisement
03 Your driving environment
Lighting
NOTE
•
The use of daytime running lights is
mandatory in Canada.
•
Continuous high beams cannot be acti-
vated when the headlight switch is in
position
or 0. High beam flash will
03
function in these positions.
Active Bending Lights (ABL)*
Headlight pattern with the Active Bending Light
function deactivated (left) and activated (right)
When this function is activated, the headlight
beams adjust laterally to help light up a curve
according to movements of the steering wheel
(see the right-pointing beam in the illustration).
ABL is activated automatically when the engine
is started and it can be deactivated/reactivated
*
90
Option/accessory, for more information, see Introduction.
in the menu system under
Car settings
Light settings
Active bending
NOTE
This function is only active in twilight or dark
conditions, and only when the vehicle is in
motion.
If a fault should occur in the system, the symbol
will illuminate and a message will be displayed
as shown in the table.
Symbol
Display
Headlamp
failure
Service
required
I n f o r m a t i o n P r o v i d e d b y :
Parking lights
lights.
Explana-
Headlight control in position for parking lights
tion
The front and rear parking lights can be turned
on even when the ignition is switched off.
The system
is not func-
Turn the headlight control to the center posi-
tioning
tion (the license plate lighting comes on at the
properly and
same time).
should be
The lighting also comes on when the trunk is
inspected/
opened in order to alert anyone traveling
repaired by
behind your vehicle.
a trained
and qualified
Volvo serv-
ice techni-
cian.
Advertisement
Table of Contents
