Table of Contents
Advertisement
03 Your driving environment
Instruments and controls
Reminder – doors not closed
If one of the doors, the hood or trunk lid is not
closed properly, the information or warning
symbol comes on together with an explanatory
text message in the instrument panel. Stop the
vehicle in a safe place as soon as possible and
close the door, hood or trunk.
03
If the vehicle is driven at a speed
lower than approximately 5 mph
(7 km/h), the information symbol comes on.
If the vehicle is driven at a speed
higher than approximately 5 mph
(7 km/h), the warning symbol comes on.
Trip odometers
Trip odometers and reset button
76
Odometer display
Button for toggling between
and for resetting the odometer
The trip odometers are used to measure short
distances. A short press the button toggles
between the two trip odometers
long press (more than 2 seconds) resets an
active trip odometer to zero. The distance is
shown in the display.
Clock
Clock and setting control
Display
Control for setting the clock
I n f o r m a t i o n P r o v i d e d b y :
Turn the control clockwise/counterclockwise
to set the time. The set time is shown in the
T1
and
T2
,
information display.
The clock may be temporarily replaced by a
symbol in conjunction with a message, see
page 124.
T1
and
T2
. A
Analogue clock (S80 Executive only)
Analogue clock
Button for setting the clock back.
Burton for setting the clock ahead.
The analogue clock is located on the dash-
board, above the glove compartment.
Use either of the buttons to move the clock's
hands back or ahead. This can be done in two
ways:
Advertisement
Table of Contents
