Table of Contents
Advertisement
Basic operations
1
Source lamps
1
Turn on the power
Press
STANDBY/ON (or
remote control).
The standby lamp goes off and the current source lamp lights
in red.
Current source name appears.
To turn off the power (into standby):
Press
STANDBY/ON (or
again.
The standby lamp lights in red.
NOTES
• A small amount of power is consumed in standby mode. To turn the
power off completely, unplug the AC power cord.
• Turning a source component on before turning the receiver on
may cause a noise or interrupt the sound and picture. In this case,
turn both the source component and the receiver off, then turn the
receiver on before turning the source component on.
20
2
3
1
2
3
AUDIO on the
AUDIO on the remote control)
2
Select the source to play
On the front panel:
Turn SOURCE SELECTOR until the source
name you want appears on the display.
The source lamp corresponding to the selected source lights
in red.
• As you turn SOURCE SELECTOR, the source changes as
follows:
DVR/DVD Ô VCR Ô VIDEO Ô TV Ô USB Ô FM Ô
AM Ô (Back to the beginning)
DVR/DVD:
Select this for the DVD recorder or DVD player.
VCR:
Select this for the VCR.
VIDEO:
Select this for the component connected to the
VIDEO IN jacks on the rear of the receiver.
TV:
Select this for the TV.
USB:
Select this for the PC component.
FM:
Select this for the FM broadcast.
AM:
Select this for the AM (MW) broadcast.
From the remote control:
Press one of the source selecting buttons.
• For "FM" and "AM," press FM/AM.
Each time you press the button, the band alternates
between "FM" and "AM."
NOTE
When you connect a video component other than DVD recorder and
DVD player to the HDMI VIDEO(VCR) IN terminal or COMPONENT
VIDEO jacks on the rear of the receiver, you need to select either
"VIDEO" or "VCR" for each terminal according to the component you
connect (see page 34).
3
Adjust the volume
To increase the volume, turn MASTER
VOLUME control clockwise (or press
VOLUME + on the remote control).
To decrease the volume, turn MASTER
VOLUME control counterclockwise (or press
VOLUME – on the remote control).
• When you adjust the volume, the volume level indication
appears on the display for a while.
CAUTION:
Always set the volume to the minimum before starting any
sources. If the volume is set at its high level, the sudden blast
of sound energy can permanently damage your hearing and/
or ruin your speakers.
NOTE
The volume level can be adjusted within the range between "0"
(minimum) and "50" (maximum).
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
