JVC RX-D411S Instructions Manual page 15

7 Audio/video connection
In addition to the HDMI terminals and SCART terminals, this
receiver is equipped with three video terminals—composite
video, S-video, and component video terminals, and two
audio jacks—analog discrete 5.1 channel audio input jacks
(DVD MULTI IN) and stereo audio jacks.
• If your video components have S-video (Y/C-separation)
and/or component video (Y, P
using an S-video cable (not supplied) or component video
cable (not supplied). By using these terminals, you can get a
better picture quality in the order:
Component > S-video > Composite
CAUTION:
If you connect a sound-enhancing device such as a graphic
equalizer between the source components and this receiver,
the sound output through this receiver may be distorted.
Do not connect the AC power cord until all other connections have been made.
Connecting a DVD recorder or DVD player with its stereo output jacks:
Turn off all components before making connections.
• When you connect the components, refer also to their manuals.
NOTES
• Select the audio and video input setting according to the
connection method. See page 21 for details.
• You can enjoy digital sound if using a digital coaxial or optical
cable. When shipped from the factory, the digital coaxial terminal—
DIGITAL IN 1(DVR/DVD) on the rear of the receiver is set for a DVD
recorder and DVD player. For details of digital audio connection, see
page 14.
, P ) jacks, connect them
B R
Green
Blue
Red
White
Red
IMPORTANT:
The video signals from one type of these input jacks are
transmitted only through the video output jacks of the
same type. Therefore, if a recording video component and
a playing video component are connected to the receiver
through the video terminals of different type, you cannot
record the picture. In addition, if the TV and a playing video
component are connected to the receiver through the video
terminals of different type, you cannot view the playback
picture on the TV.*
* When connecting the TV to the receiver through the HDMI
MONITOR OUT terminal and selecting "HDMI" for the video
output setting, you can view the playback picture on the TV.
DO NOT use a TV through a VCR or a TV with a built-in
VCR; otherwise, the picture may be distorted.
Component video cable (not supplied)
DVD recorder or DVD player
Stereo audio cable (not supplied)
Å To component video output
• Connect Y, P , and P
B
ı To left/right audio channel output
: signal flow
correctly.
R
11