Ncu Parameters - Ricoh A284 Service Manual

NCU PARAMETERS

4.1 NCU PARAMETERS
The following tables give the RAM addresses and the parameter calculation units
that the machine uses for ringing signal detection and automatic dialing. The
factory settings for each country are also given. Most of these must be changed by
RAM read/write (Function 06-1), but some can be changed using NCU Parameter
programming (Function 06-2); if Function 06-2 can be used, this will be indicated in
the Remarks column. The RAM is programmed in hex code unless (BCD) is
included in the Unit column.
SM 4-57 A874