Table of Contents
Advertisement
Basic Settings
Some of the following settings are required after connecting and positioning your speakers in your listening room, while
others will make operations easier.
Recording a Source
You can record any source playing through the receiver to a cassette
deck (or a CD recorder) connected to the TAPE/CDR jacks and the
VCR connected to the VCR jacks at the same time.
While recording, you can listen to the selected sound source at
whatever sound level you like without affecting the sound levels of
the recording.
Note:
The output volume level, bass boost (see page 11), tone adjustment
(see page 11), and DSP modes (see page 19) cannot affect the
recording.
Adjusting the Front Speaker Output
Balance
If the sounds you hear from the front right and left speakers are
unequal, you can adjust the speaker output balance.
Before you start, remember....
• There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
On the front panel ONLY:
1. Press ADJUST repeatedly until
"L/R BALANCE" appears on the
display.
The display changes to show the current setting.
2. Press CONTROL UP 5/DOWN ∞
to adjust the balance.
• Pressing CONTROL UP 5 decreases the
left channel output from CNTR (Center)
to –21.
• Pressing CONTROL DOWN ∞ decreases
the right channel output from CNTR
(Center) to –21.
Changing the Source Name
When you have connected the CD recorder to the TAPE/CDR jacks
on the rear panel, change the source name shown on the display
when you select the CD recorder as the source.
On the front panel ONLY:
When changing the source name from "TAPE" to "CDR":
1. Press TAPE/CDR.
• Make sure "TAPE" appears on the display.
2. Press and hold SOURCE NAME
(TAPE/CDR) until "ASSGN. CDR"
appears on the display.
To change the source name from "CDR" to "TAPE,"
repeat the same procedure above (in step 1, make sure
appears on the display
Note:
Without changing the source name, you can still use the connected
components. However, there may be some inconvenience.
– "TAPE" will appear on the display when you select the CD
recorder.
– You cannot use the digital input (see page 15) for the CD recorder.
– You cannot use the COMPU LINK remote control system (see page
26) to operate the CD recorder.
ADJUST SETTING
Setting the Subwoofer Information
Register whether you have connected a subwoofer or not.
Before you start, remember....
CONTROL
DOWN
UP
• There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
On the front panel ONLY:
1. Press SETTING repeatedly until
"SUBWOOFER" appears on the
display.
The display changes to show the current setting.
2. Press CONTROL UP 5/DOWN ∞
to register whether you have
connected a subwoofer or not.
• Each time you press the button, the
subwoofer setting alternates between
"YES" and "NO."
YES:
NO:
).
Select this when a subwoofer is used.
up on the display (see page 9.)
Select this when no subwoofer is used.
TAPE/CDR
SOURCE NAME
"CDR"
T SETTING
CONTROL
DOWN
UP
lights
S.WFR
12
Hide quick links:
Advertisement
Table of Contents
