Digital Input (Digital In) Terminal Setting; Selecting The Analog Or Digital Input Mode - JVC RX-6510VBK Instructions Manual

Digital Input (DIGITAL IN) Terminal
Setting
When you use the digital input terminals, you have to register what
components are connected to which terminals (DIGITAL IN 1/2).
Before you start, remember...
• There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
On the front panel ONLY:
1. Press SETTING repeatedly until
"DIGITAL IN" appears on the
display.
The display changes to show the current setting.
DIGITAL 2 terminal setting
DIGITAL 1 terminal setting
2. Press CONTROL UP 5/DOWN ∞
to select the appropriate digital
terminal setting.
• Each time you press the button, the display
changes to show the following:
1 DVD 2 CD " 1 DVD 2 TV " 1 DVD 2 CDR "
1 CD 2 DVD " 1 CD 2 TV
1 TV 2 DVD " 1 TV 2 CD
1 CDR 2 DVD " 1 CDR 2 CD " 1 CDR 2 TV "
(back to the beginning)
Note:
When shipped from the factory, the DIGITAL IN terminals can be used
as the digital input for the following components.
• DIGITAL 1 (coaxial): For DVD player
• DIGITAL 2 (optical): For CD player
15
T SETTING
CONTROL
DOWN UP
" 1 CD 2 CDR "
" 1 TV 2 CDR "
Selecting the Analog or Digital Input
Mode
When you have connected digital source components, you need to
select the input mode correctly according to the connection you
made.
Before you start, remember...
• The digital input (DIGITAL IN) terminal setting should be
correctly done for the sources you want to select the digital
input mode for. Without setting this digital input terminal
correctly, you cannot change the input mode from analog input to
digital input even if you follow the procedure below.
On the front panel:
1. Press one of the
source selecting
buttons (DVD, TV
SOUND, CD, or
TAPE/CDR)* for
which you want to change the
input mode.
Note:
* Among the sources listed above, you can select the digital input
only for the sources which you have selected the digital input
terminals for. (See "Digital Input (DIGITAL IN) Terminal Setting.")
2. Press INPUT ANALOG/DIGITAL
to change the input mode.
• Each time you press the button, the input
mode changes as follows:
AUTO
(Digital)
AUTO: Select this for the digital input mode. The receiver
automatically detects the incoming signal format.
(The DIGITAL AUTO indicator lights up on the
display, and the digital signal indicator for the
detected signals also light up.)*
ANALOG: Select this for the analog input mode.
* The followings are the analog/digital signal indicators on the
display to indicate what type of the signal comes into the
receiver.
: Lights up when "AUTO" is selected as
DIGITAL AUTO
the digital input mode.
: Lights up when the analog input is
ANALOG
selected.
: Lights up when Linear PCM signals
LINEAR PCM
come in.
DIGITAL
: Lights up when Dolby Digital signals
come in.
: Lights up when DTS Digital Surround
signals come in.
DVD VTR TV SOUND
CD TAPE/CDR FM/AM
SOURCE NAME
INPUT
ANALOG/DIGITAL
INPUT ATT
ANALOG