Digital Connections - JVC RX-6510VBK Instructions Manual

TV
To S-video input
To composite video input
PHONO
Connect the TV to the MONITOR
OUT jack to view the playback
CD
picture from the other connected
video components.
OUT
(REC)
TAPE
CDR
IN
(PLAY)
OUT
(REC)
VCR
IN
(PLAY)
TV
TV SOUND
To audio
RIGHT
output
AUDIO
DVD player
• When you connect the DVD player with stereo output jacks:
A
DVD player
LEFT
RIGHT
DVD
AUDIO
Å To front left/right channel audio output (or to audio mixed
output if necessary)
ı To S-video output
Ç To composite video output
7
MONITOR
OUT
DVD
OUT
(REC)
VCR
IN
(PLAY)
VIDEO
LEFT
B C
DVD
MONITOR
OUT
DVD
OUT
(REC)
VCR
IN
(PLAY)
VIDEO

Digital connections

This receiver is equipped with two DIGITAL IN terminals — one
digital coaxial terminal and one digital optical terminal.
You can connect any component to one of the digital terminals using
a digital coaxial cable (not supplied) or digital optical cable (not
supplied).
IMPORTANT:
• When connecting the DVD player or digital TV broadcast tuner
using the digital terminal, you also need to connect it to the video
jack (either composite video terminal or S-video terminal) on the
rear. Without connecting it to the video jack, you can view no
playback picture.
• After connecting the components using the DIGITAL IN terminals,
set the following correctly if necessary.
– Set the digital input (DIGITAL IN) terminal setting correctly. For
details, see "Digital Input (DIGITAL IN) Terminal Setting" on page
15.
– Select the digital input mode correctly. For details, see "Selecting
the Analog or Digital Input Mode" on page 15.
Digital TV
CD player
When the component has a digital
coaxial output terminal, connect it to the
DIGITAL 1 (DVD) terminal, using the
digital coaxial cable (not supplied).
When the component has a digital
optical output terminal, connect it to the
DIGITAL 2 (CD) terminal, using the
digital optical cable (not supplied).
Before connecting a digital
optical cable, unplug the
protective plug.
Notes:
• When shipped from the factory, the DIGITAL IN terminals have
been set for use with the following components.
– DIGITAL 1 (coaxial): For DVD player
– DIGITAL 2 (optical): For CD player
• When you want to operate the CD player or CD recorder using the
COMPU LINK remote control system, connect the target
component also as described in "Analog connections" (see page 5).
DVD player
DVD
CD recorder
DIGITAL 1
(DVD)
DIGITAL 2 ( CD )
DIGITAL IN