Table of Contents
Advertisement
2. Blue Adjustment
1) Place a cap on the red lens so that green and blue colors are
displayed.
2) Press "3" button on the commander to select BLU mode.
3) Adjust the following items so that blue lines overlap with
green lines.
• BLU CENT (horizontally/vertically)
• BLU SKEW (horizontally/vertically)
• BLU SIZE (horizontally/vertically)
• BLU LIN (horizontally/vertically)
• BLU KEY (vertically)
• BLU PIN (horizontally/vertically)
• BLU MLIN (horizontally)
• BLU MSIZ (horizontally)
4) Press "9" button on the commander to enter the fine adjust-
ment mode.
5) Make fine adjustment so that horizontal lines and vertical
lines overlap with green lines.
6) Press "9" button on the commander to return to the rough
adjustment mode.
3. Red Adjustment
1) Place a cap on the blue lens so that green and red colors are
displayed.
2) Press "3" button on the commander to select RED mode.
3) Hereinafter, use same manner as that of blue adjustment to
adjust so that the red lines overlap with green lines.
4. Registration Data Writing
1) After each adjustment of green, blue, and red for the
DRC100 (PAL-Wide) mode finished, press "
"-" buttons on the commander to write registration data to
the NVM.
<Copy of All Registration Data>
1. Make sure that the adjustment for DRC100 (PAL-Wide)
mode finished and the data have already been written.
2. Select the Projector Engine mode.
3. Select ALCP and set the data to "01", and press "
(MUTE)"+"-" buttons on the commander.
4. The data of DRC100 (PAL-Wide) mode are copied to all
other modes.
DRC100
(PAL)
Zoom
14 : 9
Smart
<Adjustment for DRC100 (PAL-Smart) Mode>
SPEC
Input Signal
PAL SPCB
1. Place the caps on the red and blue lenses so that only the
green color is displayed.
2. Enter the PAL SPCB signal to set the DRC100 (PAL) mode.
3. Set the screen format to "Smart".
4. Select the Projector Engine mode.
5. Press "6" button on the commander to display internal test
signal (crosshatch).
6. Hereinafter, use same manner as that of adjustment for
(MUTE)"+
DRC100 (PAL-Wide) mode to perform the green adjust-
ments.
9. Press "9" button on the commander to enter the fine adjust-
ment mode.
10. Make a fine adjustment so that horizontal lines and vertical
lines become straight.
11. Press "9" button on the commander to return to the rough
adjustment mode.
12. Hereinafter, use same manner as that of adjustment for
DRC100 (PAL-Wide) mode to perform the blue and red ad-
justments.
13. After each adjustment of green, blue, and red
for the DRC100 (PAL-Smart) mode finished, press
"
(MUTE)"+"-" buttons on the commander to write reg-
istration data to the NVM.
– 43 –
KP-44PS2/44PS2U/51PS2
DRC100
(PAL)
Wide
Copy Registration Data.
DRC50
DRC100
(PAL)
(NTSC)
Wide
Wide
Zoom
Zoom
14 : 9
14 : 9
Smart
Smart
Overscan Spec. = 7.5%
H SIZE
17.0 ± 0.1 sq.
11.2 ± 0.1 sq.
RM-903
DRC50
(NTSC)
Wide
Zoom
14 : 9
Smart
V SIZE
Advertisement
Table of Contents
