Table of Contents
Advertisement
KP-44PS2/44PS2U/51PS2
RM-903
1-1. RE-3W SELF DIAGNOSTIC SOFTWARE
The identification of errors within the RE-3W chassis is triggered in one of two ways : - 1: Busy or 2: Device failure to respond to IIC.
In the event of one of these situations arising the software will first try to release the bus if busy (Failure to do so will report with a
continuous flashing LED) and then communicate with each device in turn to establish if a device is faulty. If a device is found to be
faulty the relevant device number will be displayed through the LED (Series of flashes which must be counted) See table 1., non fatal
errors are reported using this method.
Diagnostic Item
Description
Power does not turn on
+B Overcurrent (OCP)
Vertical Deflection stopped
SELF DIAGNOSIS FUNCTION
No. of times Standby
LED Flashes
Power cord is not plugged in
Does not light
Fuse is open circuit
H. OUT (Q5104) is shorted (D Board)
2 times
Linearity FET (Q5105) is shorted (D Board)
IC6004 Power IC is shorted (G Board)
+15 V is not supplied R5340 open (D Board)
4 times
–15 V is not supplied R5341 open (D Board)
IC5302 is shorted (D Board)
No error
Not allowed (may be confused with Sircs response flash)
Over Current Protection
Over Voltage Protection
Vertical Protection
Not used
Horizontal Protection
Speaker Protection
General IIC Line 0 error
MEGATEXT (IC9502)
NVM (IC9108)
Main colour decoder (IC8301)
Backend (IC4301)
Multi sound processor (IC4702)
External RAM (IC9107)
Flash Timing Example : e.g. error number 3
Standby LED
ON
SECTION 1
Probable cause Location
ERROR
ON
OFF
OFF
– 4 –
Detected Symptoms
Power does not come on
No power is supplied to the TV
AC power supply is faulty
Power does not come on
Load on power line has shorted
Vertical deflection pulse has stopped
Power line has shorted
LED
ERROR
COUNT
00
01
02
03
04
05
06
07
08
09
10
11
14
15
17
ON
Advertisement
Table of Contents
