Panasonic Lumix DMC-LX100 Owner's Manual page 155

●
This function is not intended for application-specific systems (monitoring cameras).
●
If you leave the camera unattended during [Time Lapse Shot] recording, make sure that the
camera is not stolen.
●
Exercise caution when you perform [Time Lapse Shot] recording for a long period of time
in cold regions or in a low-temperature or high-temperature/high-humidity environment,
since such use could cause malfunctions.
●
The camera may not be able to record using the preset interval and number of pictures to be
recorded under some recording conditions.
●
If the recording time is longer than the preset interval due to a long exposure, this may cause the
recording to skip.
●
Use a sufficiently charged battery or an AC adaptor (optional) and DC coupler (optional).
●
[Time Lapse Shot] is paused in the following cases:
• When the remaining battery power runs out
• Turning the camera off
If this occurs during [Time Lapse Shot] recording, you can restart the operation by replacing
the battery or card in the pause state and turning the Camera [ON/OFF] switch to [ON]. (Note,
however, that the pictures recorded after restarting the operation are saved as another group
picture.) When you replace the battery or card, turn the Camera [ON/OFF] switch to [OFF].
●
Do not connect the AV cable (optional), HDMI micro cable or USB connection cable (supplied)
during [Time Lapse Shot] recording.
●
When you select the picture quality for an aspect ratio that is different from the original picture, the
picture will be displayed with a black band on the upper/lower side or the left/right side of a stop
motion animation.
●
If the power supply is cut off due to a power outage or AC adaptor disconnection while a motion
picture is being recorded using the AC adaptor (optional), that motion picture will not be recorded.
●
You cannot create a motion picture that is longer than 29 minutes 59 seconds, or whose file
exceeds 4 GB.
●
When a stop motion animation is shorter than 2 seconds, "2s" will be displayed for the motion
picture recording time (→70).
●
When the number of recorded pictures is one, it will not be saved as a group picture.
Not available in the following cases:
●
[Time Lapse Shot] cannot be used In the following cases:
• During panorama picture recording
• When [Multi Exp.] is set
• When using [Stop Motion Animation]
• When the [Simultaneous record w/o filter] is set to [ON]
155
Functions for specific subjects and purposes
Taking pictures automatically at set intervals [Time Lapse Shot]
SQW0021