Figure 5-15. Vor/Loc/Gs Cdi Page - Garmin GNS 530W Installation Manual

5.3.12 VOR/LOC/GS CDI Page (GNS 530W Only)
Select the VOR/LOC/GS CDI page (see Figure 5-15). This
page allows you to verify and calibrate the CDI outputs, both
lateral (LAT) and vertical (VERT) from the
VOR/LOC/Glideslope receiver, as well as the OBS resolver
input to the VOR receiver. It also allows you to select the
format for DME tuning data. Using the controls on the GNS
530W front panel, make the selections below and verify the
interfaces as appropriate:
The LAT, VERT, and SELECTED COURSE configurations only apply to installations
where a CDI/HSI is connected to the VOR/LOC/GLIDESLOPE pins on connector
P5006.
CDI (LAT/VERT)
Selection
Max left
Full left
Std. left
Center
Std. right
Full right
Max right
NAV FLAG (LAT/VERT)
Selection
Hide
View
SPR-FLG (LAT/VERT)
Selection
Hide
View
TO-FROM (LAT)
Selection
FROM
Hide
TO
SELECTED COURSE
Select 150° on the CDI/HSI that is connected to the 500W Series unit VOR/LOC/GS OBS inputs. The
SELECTED COURSE field should indicate near to 150° and a Calibrate to 150°? field appears.
Selecting this field calibrates the 500W Series unit to match the input source. Verify OBS operation by
checking that the course displayed on the 500W Series unit is within 2° of the selected course. Do this at
30° intervals around the OBS card.
Page 5-16
Rev. D
Verify That:
The CDI is "pegged" to the left.
The CDI is deflected full scale to the left.
The CDI is deflected left of center.
The CDI is centered.
The CDI is deflected right of center.
The CDI is deflected full scale to the right/down.
The CDI is "pegged" to the right/down.
Verify That:
The LAT/VERT flag is hidden.
The LAT/VERT flag is in view.
Verify That:
The LAT/VERT superflag is hidden.
The LAT/VERT superflag is in view.
Verify That:
The FROM flag is in view.
The TO/FROM flag is hidden.
The TO flag is in view.

Figure 5-15. VOR/LOC/GS CDI Page

NOTE
500W Series Installation Manual
190-00357-02