Figure 5-6. Main Inputs Page; Figure 5-7. Instrument Panel Self-Test Page - Garmin GNS 530W Installation Manual

COM Presets (Main software version 3.00 or later)
Selection
Disabled
Enabled
5.3.4 MAIN INPUTS Page
Select the MAIN INPUTS page (see Figure 5-6). This page allows you to monitor the data on ARINC
429, RS-232 and other electrical inputs. This is used for verifying electrical interfaces during installation
and troubleshooting. Information that is not being received by the 500W Series unit is dashed out.
Field Description
OAT Outside Air Temperature
SAT Static Air Temperature
TAT Total Air Temperature
Indicated Airspeed
IAS
True Airspeed
TAS
Wind Speed
W SPD
HDG True Heading
Wind Direction
W DIR
GPS Selected Course
GPS SC
VLC SC VOR/LOC Selected Course (GNS 530W
Only)
Status of the CDI key (GNS 530W Only).
CDI
B ALT Barometric-corrected Altitude
Density Altitude
D ALT
Pressure Altitude
P ALT
L FF Left Engine Fuel Flow
Right Engine Fuel Flow
R FF
T FF Total Fuel Flow
Total Fuel on Board
T FOB
Latitude and longitude of a joystick waypoint
JOYSTICK
sent by an EFIS or RADAR indicator.
WPT
5.3.5 INSTRUMENT PANEL SELF-TEST Page
Select the INSTRUMENT PANEL SELF-TEST page (see
Figure 5-7). This page allows verification that the 500W
Series unit is communicating properly with other
instruments. Compare on-screen indications with the
information depicted on connected instruments, such as the
CDI, HSI, RMI and/or external annunciators. It also
displays fuel capacity, amount on-board, and flow.
Page 5-8
Rev. D
Description
The COM Configuration Aux page is not available to the pilot.
The COM Remote Recall discrete input is connected in the installation
(refer to 4.5.1.16 for additional details). When COM presets are
enabled, the user is able to preset COM frequencies and load them
into the standby COM frequency using a remote switch.

Figure 5-6. MAIN INPUTS Page

Figure 5-7. INSTRUMENT PANEL SELF-
TEST Page
500W Series Installation Manual
190-00357-02