Garmin GNS 530W Installation Manual page 19

1.4.5 VOR Specifications (GNS 530W Only)
Receiver Audio Sensitivity
Course Deviation Sensitivity
Flag
AGC Characteristics
Spurious Response
VOR OBS Bearing Accuracy
Audio Output
Audio Response
Audio Distortion
1.4.6 LOC Specifications (GNS 530W Only)
Receiver Audio Sensitivity
Course Deviation Sensitivity
Flag
AGC Characteristics
Selectivity
Spurious Response
Centering Accuracy
Audio Output
Audio Response
Audio Distortion
500W Series Installation Manual
190-00357-02
At -103.5 dBm (S+N)/N is not less than 6 dB.
-103.5 dBm or less for 60% of standard deflection.
The VOR Course Deviation Flag must be flagged:
a) in the absence of an RF signal.
b) in the absence of the 9960 Hz modulation.
c) in the absence of either one of the two 30 Hz modulations.
d) When the level of a standard VOR deviation test signal
produces less than a 50% of standard deflection.
From -99 dBm to -13 dBm input of a Standard VOR Audio Test
Signal, audio output level does not vary more than 3 dB.
Greater than 80 dB.
The bearing information as presented to the pilot does not have an
error in excess of 2.7° as specified by RTCA DO-196 and EuroCAE
ED-22B.
A minimum 100 mW into a 500Ω load.
Less than 6 dB of variation between 350 and 2500 Hz. Except the
1020 Hz Ident Tone is at least 20 dB down in voice mode.
The distortion in the receiver audio output does not exceed 10% at
all levels up to 100 mW.
At -103.5 dBm (S+N)/N is not less than 6 dB.
-103.5 dBm or less for 60% of standard deflection.
The LOC Course Deviation Flag must be flagged:
a) In the absence of an RF signal.
b) When either the 90 or 150 Hz modulating signals is removed
and the other is maintained at its normal 20%.
c) In the absence of both 90 and 150 Hz modulation.
d) When the level of a standard localizer deviation test signal
produces less than a 50% of standard deflection.
From -86 dBm and -33 dBm input of a Standard VOR Audio Test
Signal, audio output level does not vary more than 3 dB.
Nose Bandwidth: The input signal level required to produce the
reference AGC voltage does not vary more than 6 dB over the
input signal frequency range of ± 9 kHz from the assigned channel
frequency.
Skirt Bandwidth: The input signal level required to produce
reference AGC voltage is at least 70 dB greater than the level
required to produce reference AGC voltage at the assigned
channel frequency at ± 36 kHz from the assigned channel
frequency.
Greater than 80 dB.
Typical 0 ± 3 mV (Max error 9.9 mV per RTCA DO-195).
A minimum 100 mW into a 500Ω load.
Less than 6 dB of Variation between 350 and 2500 Hz. Except the
1020 Hz Ident Tone is at least 20 dB down in voice mode.
The distortion in the receiver audio output does not exceed 10% at
all levels up to 100 mW.
Page 1-7
Rev. D