NeoPro Imperial Integrator Manual page 11

Setup:Disp Lamp
This option will set the display brightness to one of four levels.
The default is 100%
Setup:AC Pwr
This option control what the matrix will do when AC power is first
applied, or after a power outage. Selecting "ON" (default) will
force the unit to turn on, and the previous switch state will be
restored. Selecting "Stby" will cause the unit to enter standby
mode.
Setup:Touchpanel
This option will disable the front panel buttons. The default in ON
Setup:TouchSense
Setup:TouchDelay
These two options work together to control the front panel touch
button performance. The TouchSense setting controls the overall
sensitivity, while the TouchDelay setting controls the detection
delay, similar to a 'debounce' function.
If the buttons are falsely triggered by outside interference, setting
the TouchSense to "LOW" and the TouchDelay to "HIGH" will
likely remedy the situation.
If the buttons are difficult to press with smaller fingers, setting the
TouchSense to "HIGH" will improve the sensitivity. Setting the
TouchDelay to "LOW" will not change the sensitivity, but will
make the button response seem faster.
Any of the above selections will be applied instantly. There is no
need to save the changes. At any time the user may press exit to
return to the home screen, or wait 10 seconds and the home screen
will return on it's own.
11
Imperial Matrix Switch User's Guide (DOC42-00010-A_NeoPro-Imperial.doc)