Sym Joyride125 Service Manual page 94

Install snap ring and mounting plate onto setting
pin.
Replacement of Driven Pulley Bearing
Remove inner bearing.
Caution
If the inner bearing equipped with oil seal
on side in the driven pulley, then remove
the oil seal firstly.
If the pulley equipped with ball bearing, it
has to remove snap ring and then the
bearing.
Remove snap ring and then push bearing
forward to other side of inner bearing.
Place new bearing onto proper position and its
sealing end should be forwarded to outside.
Apply with specified oil.
Install new inner bearing.
Caution
Its sealing end should be forwarded to
outside as bearing installation.
Install needle bearing with hydraulic
presser. Install ball bearing by means
of hydraulic presser.
Install snap ring into the groove of driving face.
Align oil seal lip with bearing, and then install
the new oil seal (if necessary).
8. V-BELT DRIVING SYSTEM/KICK STARTER
To this chapter contents
Outer bearing
Snap ring
Inner needle
bearing
Specified oil
Inner bearing
Snap ring
Clipper
Inner ball
bearing
Snap ring
Outer bearing
Sealing end
Sealing end
8-13