Self-Programming Mode - Midland CT210 Owner's Manual

Self-Programming mode

To enter in Self-Programming mode, follow these steps:
1. while turning on the unit, hold down 'MONI' and
2. press ;
3. turn the Encoder knob and select the memory number to program;
4. push again;
5. digit the desired rx frequency;
6. press ;
7. press and with the Encoder knob select the desired CTCSS in RX (if you
press it again, you can select a DCS code);
8. press ;
9. digit the desired tx frequency;
10. push ;
11. press and with the Encoder knob select the desired CTCSS in TX (if you
press it again, you can select a DCS code);
12. press ;
13. with the Encoder knob, enable/disable the busy channel lockout (you can
choose: OFF, 1 carrier, 2 CTCSS/DCS);
14. press ;
15. by turning the Encoder knob, you can enable/disable the priority channel
scanning;
16. press ;
17. turn the Encoder knob and select the power level in tx H (high) or L (low);
18. press ;
19. turn the Encoder knob and select the transmission mode: WIDE or
NARROW;
20. push ;
21. rotate the Encoder knob and select the first letter for the name of the
programmed channel. To switch to the next channel, push the
and turn the Encoder knob;
22. press ;
23. switch off the unit to finish the programming procedure and return to the
standard modality.
until 'SELF' is displayed;
button
17