Delete Channel; Programming Scan; Turn On/ Off Fm Radio - Midland CT310 Instruction Manual

Delete channel

1. Under standby state, press FUNC, the top left corner of LCD displays
icon, press V/M to switch into channel mode, channel number flashes.
2. Rotate the channel switch to select the channel number you want to delete.
3. Press FUNC, the top left corner of LCD displays
V/M until the transceiver emits "DUDU" beep and clear up frequency
information of current channel, deletion is successful.
NOTE: This process can be applied for deleting FM radio channels.

Programming scan

Setup the frequency of L1 channel, U1 channel, L2 channel and U2 channel
will realize VFO frequency scanning border limited. L1 & L2 are the starting
frequencies, U1 & U2 are the last frequencies.
When the VFO frequency is between L1 ~ U1 or L2 ~ U2, the transceiver will
scan the frequencies between L1 ~ U1 or L2 ~ U2. When the VFO frequency
is lower than L1 or L2, transceiver will scan frequencies higher than L1 or L2.
When VFO frequency is higher than U1 or U2, transceiver will scan frequencies
higher than U1 or U2.
1. In VFO mode, enter the desired frequency and relative setup, press
FUNC, the top left corner of LCD displays
into channel mode, the channel number flashes.
2. Rotate channel switch to choose the desired channel number.
3. Press FUNC, the top left corner of LCD displays
until the transceiver emits "DUDU" beep, channels are saved successfully.
NOTE: To make this setup, L1 and U1 must be in the same frequency band. L2 and
U2 must be in the same frequency band.

Turn On/ Off FM Radio

In standby mode, press FUNC, the top left corner of LCD displays
then press FM: LCD displays "FM ON" and the current FM radio frequency.
The FM radio function is activated. You can mute the radio by pressing MAIN,
the LCD displays "FM OFF".
When FM radio is on, press FUNC, the top left corner of LCD displays
icon; press FM to turn off the FM radio and return to the transceiver mode.
Re-start transceiver also can exit FM radio function.
NOTE: To use the FM radio function, you must set RADIO function on 30th
menu, otherwise the FM radio function cannot be used normally.
CT310 Instruction Manual
icon, press and hold
icon, then press V/M switch
icon, then press V/M
icon,
| 15