Setting Remote Monitor Mode - Midland G15 GMRS Portable Owner's Manual

Using accessories while in "VOX" mode.
Accessories for private listening are available. Those with a "VOX/PTT" switch
built in can be used with the G15 in "VOX" mode. Turn on the radio. Set the radio to
"VOX". Set the accessory VOX/PTT switch to" VOX".
!
Key beep tones may sound very loud when using a headset or earpiece. We
advise turning off tones and avoid using the call feature when using accessories.

SETTING REMOTE MONITOR MODE

1. Choose a channel to be used, set BOTH radios to that channel.
2. With the radio to be used for the monitor off, press and hold the "ENTER" button
and turn the radio on.
3. Release the "ENTER" button when the radio powers up.
4. Press and release the "F" button repeatedly until "bb" (usually 5 times) is on the
display.
5. Press and release the "/\" or "\/" button repeatedly to select the sensitivity level.
"
The two numbers to the right of the "bb" is the sensitivity. This can be set from
01 to 06. A sensitivity level of 01 is the most sensitive.
6. Adjust the volume as desired.
7. Press and release the "ENTER" button to activate remote monitor mode.
"
The radio will enter monitor mode after 1 minute. If the remote radio hears a
sound, the radio will send the call signal. After the call is complete the remote
radio will transmit for 10 seconds. This allows you to hear the sound. After the
10 seconds of transmit is complete, the remote radio will go to receive for 10
seconds allowing you to transmit to the remote radio. This cycle continues 3
times then the remote radio goes back to monitor mode.
"
To ensure reliable communications, be certain fresh batteries are used.
!
WARNING This monitoring is NOT intended in any way as a life saving device.
To exit the remote monitor mode
Switch the radio off then on.
14