Peripherals Settings; Peripherals Pairing Ciscotouchpanels Remotepairing; Peripherals Profile Touchpanels - Cisco TelePresence SX10 Quick Set Administrator's Manual

Cisco TelePresence SX10 Quick Set
Contents

Peripherals settings

Peripherals Pairing CiscoTouchPanels RemotePairing

In order to use Cisco Touch 10 (touch controller) as user interface for the video system, Touch
10 must be paired to the video system via the network (LAN). This is referred to as remote
pairing.
Remote pairing is allowed by default; you must switch this setting Off if you want to prevent
remote pairing.
Requires user role: ADMIN
Value space: <Off/On>
Off: Remote pairing of Touch 10 is not allowed.
On: Remote pairing of Touch 10 is allowed.
Peripherals Pairing CiscoTouchPanels RemotePairing: On
Example:

Peripherals Profile TouchPanels

Set the number of touch panels that are expected to be connected to the video system. This
information is used by the video system's diagnostics service. If the number of connected touch
panels does not match this setting, the diagnostics service will report it as an inconsistency.
Note that only one Cisco Touch controller is supported in this version.
Requires user role: ADMIN
Value space: <NotSet/Minimum1/0/1/2/3/4/5>
NotSet: No touch panel check is performed.
Minimum1: At least one touch panel should be connected to the video system.
0-5: This number of Touch controllers should be connected to the video system.
Peripherals Profile TouchPanels: NotSet
Example:
D15106.02 SX10 Quick Set Administrator Guide TC7.2, AUGUST 2014.
Introduction Web interface System settings System settings
www.cisco.com — Copyright © 2014 Cisco Systems, Inc. All rights reserved.
77
Administrator Guide
Setting passwords Appendices