Controlling Your Camera - Cisco TelePresence SX10 Quick Set Administrator's Manual

Cisco TelePresence SX10 Quick Set
Contents

Controlling your camera

You can control the camera from the Call Control page.
The camera controls (pan, tilt, zoom) are available when the
cursor is placed in the Main Source video area.
Note that the camera controls are not available if the system
is in standby mode.
D15106.02 SX10 Quick Set Administrator Guide TC7.2, AUGUST 2014.
Introduction Web interface Web interface
Navigate to: Call Control
Pan and tilt
Use the left and right arrows
to pan the camera, and the up
and down arrows to tilt it.
System settings
www.cisco.com — Copyright © 2014 Cisco Systems, Inc. All rights reserved.
18
Administrator Guide
Setting passwords Appendices
Use + and - to zoom in and out.
Camera preset
Click the preset's name to move the
camera to it's default position.
Click OK to close the window.
Zoom