Wall Mounting - Cisco Catalyst Express 500 Getting Started Manual

Wall-mounting
Position the mounting bracket and screw on the side of the
switch, rotated 90-degrees from the view shown in the
rack-mounting illustration. Tighten the screw with a
screwdriver. Repeat on the opposite side.
Mount the switch on the wall with the front panel facing up. For
the best support of the switch and cables, make sure that the
switch is attached securely to wall studs or to a firmly attached
plywood mounting backboard. Screws for wall-mounting are
not provided.
If your switch has a redundant power supply (RPS) connector
on the rear panel, make sure that the cover plate is installed if
an RPS is not connected to the switch.
14