Cisco Catalyst Express 500 Getting Started Manual page 18

Checklist
Did you start a browser
session on your PC before
the SETUP LED was solid
green?
Did you start a browser
session on your PC and
the set-up page did not
appear?
Did you have a pop-up
blocker running on your
PC when you connected
to the switch port?
Did you have proxy
settings enabled in your
browser software when
you connected to the
switch port?
Did you have a wireless
client running on your PC
when you connected to
the switch port?
Do you need to change
the switch IP address after
you have already
completed the initial
setup?
18
Recommendation
If yes, or you are not sure, restart
the switch. Perform Step 2
through Step 6. When the SETUP
LED is solid green, start a browser
session on your PC. Complete the
set-up procedure.
If the window does not appear,
enter a URL in your browser, such
as cisco.com, or another
well-known website.
If yes, disconnect the cable from
the switch port, disable the
pop-up blocker, and reconnect to
the switch. Press the SETUP
button to continue.
If yes, disconnect the cable from
the switch port, disable the proxy
settings, and reconnect to the
switch. Press the SETUP button to
continue.
If yes, disconnect the cable from
the switch port, disable the
wireless client, and reconnect to
the switch. Press the SETUP
button to continue.
Go to the Configure > Express
Setup device manager screen to
change the switch IP address. For
more information about changing
the swith IP address, see the User
Guide for the Catalyst Express
500 Switches online at Cisco.com.