Renesas Promotional board Quick Start Manual page 5

Promotional board for rx210

Enlarged version

45. Select Advanced Debug Tutorial, Click Finish.

46. Click OK to dismiss the Project Generator Information dialog.

47. Adjust the jumpers to allow debugging:

Remove the jumper on J15 to enable the debugger circuit.

Fit the jumper to J6.

Set the J11 jumper to 2-3 to power from USB.

48. Insert the USB cable.

49. Connect to the device using the [Debug->Connect] menu item.

50. Ensure that Debugging Mode is selected, Click OK.

51. Dismiss the Configuration Properties dialog using the OK button.