Renesas Promotional board Quick Start Manual page 3

Promotional board for rx210

Enlarged version

25. Click OK to dismiss the Project Generator Information dialog.

26. Select [Debug->Connect]

27. To reprogram the LowPowerDemo into the flash, select "Writing the on-chip flash memory mode" to program

the device (recommended for current measurement) or "Debugging mode" to debug.

28. On the Startup and Communication Tab, select:

Mode Pin Settings:

Single-chip Mode

Endian:

Little Endian

FINE Baud Rate:

750000 bps

29. Click <OK>.

30. The debugger will now try to connect. If the connection fails here, check that the jumper settings are correct

and that the power LED is lit.

31. Dismiss the Configuration Properties dialog using the OK button