Pre-Installed Screws; Hardware Parts; Bolt; Qty: 1 - Horizon Fitness Syros Owner's Manual

ASSEMBLY Step 6
SYROS
SYROS PRO
UPPER HANDLEBAR COVER
PRE-INSTALLED ARC WASHER
PRE-INSTALLED BOLT PRE-INSTALLED SPRING WASHER
12
NOTE: There is no hardware for this step.
A Slide UPPER HANDLEBAR onto LOWER
HANDLEBAR and secure using 1 PRE-INSTALLED
BOLT, 1 PRE-INSTALLED ARC WASHER and 1
PRE-INSTALLED SPRING WASHER.
Attach the HANDLEBAR COVERS from front side
B
using 1 PRE-INSTALLED SCREW and 1 PRE-
UPPER HANDLEBAR
INSTALLED BOLT and rear side using 1 PRE-
INSTALLED BOLT.
Repeat A-B on the other side.
C
PRE-INSTALLED SCREW
PRE-INSTALLED BOLT
PRE-INSTALLED BOLT
LOWER HANDLEBAR
ASSEMBLY Step 7
HANDLBAR WIRE
HANDLEBAR CONSOLE
PRE-INSTALLED BOLT
CONSOLE MAST
PRE-INSTALLED SCREW
PRE-INSTALLED BOLT
22 21
CONSOLE MAST COVER
HarDWare partS:
BUSHING (21) T KNOB (22)
Φ8 x Φ13 x 35mm M8 x 55mm

Qty: 1

Qty: 1
A Feed the HANDLBAR WIRES through the hole in the
CONSOLE MAST and out the top of the CONSOLE
MAST.
Attach the HANDLEBAR to CONSOLE MAST using
B
1 BUSHING (21) and 1 T KNOB (22).
Connect the CONSOLE CABLES and carefully tuck
C
the CONSOLE CABLES into the CONSOLE MAST.
d Attach the CONSOLE to the CONSOLE MAST using
4 PRE-INSTALLED BOLTS.
E Attach the LEFT & RIGHT CONSOLE MAST
COVERS to the CONSOLE MAST using 4 PRE-
INSTALLED BOLTS and 1 PRE-INSTALLED
SCREW.
Plug in POWER ADAPTER.
F
NOTE: Be careful not to pinch any wires while
attaching the console.
SYROS
SYROS PRO
13