Using Recording Timer - JVC Model MX-J70J Instructions Manual

6
When selecting "– CD – – –"
1) Press 4 or ¢ to select the disc
number, then press SET.
2) Press 4 or ¢ to set the track number,
then press SET.
The unit enters volume setting mode.
When selecting "TUNER FM" or
"TUNER AM"
Press 4 or ¢ to select the preset station
number, then press SET.
The unit enters volume setting mode.
7
Press 4 or ¢ to set the volume
level.
• You can select the volume level from among
four levels. If you select " VOL – – –," the volume is
set to the last level when the unit has been turned off.
DAILY
8
Press SET to complete the Daily
Timer setting.
The DAILY indicator stops flashing and
remains lit. The settings you have done are shown on the
display in sequence.
9
Press POWER to turn off the unit
(on standby) if you have set the Daily
Timer with the unit turned on.
To turn on or off Daily Timer after its setting is done
1 Press TIMER/CLOCK repeatedly until "DAILY"
appears on the display.
2 To turn off the Daily Timer, press CANCEL.
The DAILY indicator goes off from the display.
The Daily Timer is canceled, but the setting for
the Daily Timer remains in memory.
To turn on the Daily Timer, press SET.
The DAILY indicator lights up on the display.
The settings you have done are shown on the
display in sequence for your confirmation.
If the unit is turned on when the timer-on time comes
Daily Timer does not work.
EN20-28.MX-J70[J]/f
PRESET
SEA CONTROL
PRESET
SEA CONTROL
SET
STANDBY
POWER
TIMER
/CLOCK
DEMO
CANCEL
SEA CONTROL
24

Using Recording Timer

With Recording Timer, you can make a tape of a radio
broadcast automatically.
How Recording Timer actually works
The unit automatically turns on, tunes into the specified
SET
station, sets the volume level to "0," and starts recording
when the on-time comes (the
the on-time, and continues flashing while the timer is
operating). Then, when the off-time comes ("OFF" appears
just before the off-time), the unit automatically turns off
(stands by).
The timer setting remains in memory until you change it.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 1
again.
• If you have made a mistake while setting the timer, press
CANCEL. (However, this does not always work. If
CANCEL does not work, press TIMER/CLOCK repeatedly
and start from step 1 again.)
On the unit ONLY:
1
Put a recordable cassette into deck B.
2
Press TIMER/CLOCK until "REC"
appears on the display.
The REC indicator also starts flashing on the
display.
REC
• Each time you press the button, the timer setting modes
change as follows:
DAILY
Canceled
3
Press TIMER/CLOCK again.
"ON TIME" appears for 2 seconds, then the
unit enters on-time setting mode.
SET
REC
REC
– 24 –
99.2.9, 1:34 PM
Continued
indicator flashes just before
TIMER
/CLOCK
ON TIME REC
Clock
ON TIME
setting
(See page 10.)
TIMER
/CLOCK