Recording; Recording Tapes On Deck B - JVC Model MX-J70J Instructions Manual

Recording

IMPORTANT:
• It should be noted that it may be unlawful to re-record
pre-recorded tapes, records, or discs without the
consent of the owner of copyright in the sound or video
recording, broadcast or cable programme and in any
literary, dramatic, musical, or artistic embodied
therein.
• The recording level is automatically set correctly, so it is
not affected by the VOLUME control. Thus, during
recording you can adjust the sound you are actually
listening to without affecting the recording level.
• While recording, you can hear sound modes and/or the
Signal Adaptive Bass effect through the speakers or
headphones. However, the sound is recorded without these
effects (see page 11).
• If recordings you have made have excessive noise or static,
the unit may be too close to a TV. Increase the distance
between the TV and the unit.
• You can use type I and II tapes for recording.
To protect your recording
Cassettes have two small tabs on the back to protect
unexpected erasure or re-recording.
To protect your recording, remove these tabs.
To re-record on a protected tape, cover the holes with
adhesive tape.
When using type II tape, be careful not to cover the holes
used to detect the tape type.
EN20-28.MX-J70[J]/f 20

Recording Tapes on Deck B

1
Press EJECT 0 for the deck B.
2
Put in a recordable cassette, with the exposed
part of the tape down.
3
Close the cassette holder gently.
4
Check the tape direction of deck B.
• If the tape direction is not correct, press TAPE 2 3
twice then 7 to change the tape direction.
5
Start playing the source — FM, AM*, CD
player, deck A, or auxiliary equipment
connected to AUX jacks.
• When the source is CD, you can also use CD Direct
Recording (see page 21) and Auto Edit Recording (see
page 22).
• When the source is deck A, you can also use the
dubbing method. (See "Dubbing Tapes" on page 21.)
* See "To record an AM station – Beat Cut" on page 21.
6
Start recording.
On the unit:
Press REC START/STOP.
The indicator lights up on the display and
recording starts.
On the remote control:
1) Press REC PAUSE.
The indicator starts flashing on the
display.
2) Press TAPE 2 3.
The indicator stops flashing and
remains lit, and recording starts.
To stop during recording, press REC START/
STOP again (or 7 on the remote control).
– 20 –
99.2.9, 1:34 PM
Continued
REC
START/STOP
REC PAUSE