A-Arm Assembly - E-Z-GO RXV GASOLINE Service & Repair Manual

Read all of Section B and this section before attempting any procedure. Pay particular attention to all Notices, Cautions and Warnings.

A-Arm Assembly

(Ref Fig. 5)
Tool List
Wrench, 15mm ............................................................ 1
Socket, 15mm ............................................................. 1
Ratchet ........................................................................ 1
Torque Wrench, ft. lbs. ................................................ 1
Remove the front bumper as shown in the Body section
of this manual. Remove the front wheel(s) as described
in the Wheels and Tires section of this manual.
1. Remove the hex head bolt (11) securing the a-arm
(13) to the strut.
FRONT SUSPENSION AND STEERING
Tie Rod End
Tie Rod End Nut
Fig. 5 Hub, Spindle, Strut and A-Arm Assemblies
Qty.
Repair and Service Manual
2. Remove bushings (14 & 16) from a-arm, being careful
to retain sleeve (15).
3. Inspect the sleeve (15) for wear or pitting; replace if
sleeve (15) shows signs of wear or pitting.
4. Remove two hex head bolts (17 & 18) securing the a-
arm to the frame brackets.
Reassemble in reverse order, replace worn or dam-
aged hardware as required.
Note: When reinstalling the urethane bushings (14 &
16) coat the contact surfaces with a commercially
available anti-seize compound; making sure that
none gets on the bolt or nut threads.
B
B
Page E-5