Direction Selector - E-Z-GO RXV GASOLINE Service & Repair Manual

Read all of Section B and this section before attempting any procedure. Pay particular attention to all Notices, Cautions and Warnings.
Direction
Selector
Shaft
Direction
Selector
Handle
Micro
Switch

DIRECTION SELECTOR

Prior to removing the direction selector switch from the
body, the battery negative cable must be disconnected
to prevent the possibility of electrical spark or 'shorting
out' the battery, either of which could result in an explo-
sion and severe personal injury or death.
Direction Selector
Tools List
Wrench, 10 mm ........................................................... 2
Ratchet ........................................................................ 1
Socket, 10 mm ............................................................ 1
Torx Bit, 27 IP .............................................................. 1
Phillips Screwdriver ..................................................... 1
Digital Volt Ohm Meter (DVOM) .................................. 1
NOTICE
Always observe the following warnings when working on or
near batteries:
To prevent an electrical arc that could cause
an electrical explosion, be sure that the key
switch is off and all electrical accessories are
Mounting Bracket with Bushing
Neutral Lock Pin
Neutral Lock Bracket
Direction
Selector
Cam
Fig. 1 Direction Selector
Repair and Service Manual
Push - Pull Cable
Extension Spring
Pivot Bracket
turned off before starting work on vehicle.
Never disconnect a circuit under load at a bat-
tery terminal.
The battery negative (-) cable must be
removed before starting work on vehicle.
Qty.
'shorting out' a battery, which could result in an
explosion and severe personal injury or death.
Remove screw (1) securing the direction selector handle
(2) to the direction selector shaft, remove the handle.
Remove two screws (3) attaching the direction selector
bracket to the seat frame and remove direction selector
from body.
3
Fig. 2 Direction Selector Handle
DIRECTION SELECTOR
Push - Pull Cable
Flip-Lok
Bushing
Cup
Washer
Wrap wrenches with vinyl
tape to prevent the possibility
of a dropped wrench from
B
B
2
1
Page K-1