Fujitsu PRIMERGY TX1320 M1 Operating Manual page 74

Starting up and operation
I
If the operating system does not switch the server off automatically,
press the On/Off button for at least four seconds and/or send a
corresponding control signal.
Other On/Off options
Besides the On/Off button, the server can be switched ON and OFF in the
following ways:
– Specified switch on time / switch off time
The server is switched ON or OFF at a time specified in the ServerView
Operations Manager.
– Ring indicator
The server is switched on by an internal or external modem.
– Wake On LAN (WOL) (Shared LAN only)
The server is switched on by a command via the LAN (Magic Packet)
– After power failure
The server automatically reboots following a power failure (depending of the
settings in the BIOS).
– "Power override" function
The server can be switched off immediately by pressing and holding the
On/Off button (approx. 4-5 sec.).
V
CAUTION!
There is a risk that data may be lost.
– IPMI
The server is switched on by an IPMI console via serial port COM1 (item 6
in figure 7 on page
on page 53).
74
53) or via the service LAN connection (item 1 in
Operating Manual
figure 7
TX1320 M1