Signal Strength Indicator; Manual Time Setting - Technoline RADIO CONTROLLED PROJECTOR CLOCK Instructions Manual

SIGNAL STRENGTH INDICATOR

The signal indicator displays signal strength in 4 levels.
Wave segment flashing means time signals are being
received. The signal quality could be classified into four types:
No signal quality
Acceptable signal quality
NOTE:
1. Everyday the unit will automatically search for the time
signal at 2:00, 8:00, 14:00 and 20:00.
2. Always place the unit away from interfering sources
such as TV set, computer, etc.
3. Avoid placing the unit on or next to metal plate.
4. Closed area such as airport, basement, tower block
or factory is not recommended.
5. Do not start reception on a moving article such as
vehicle or train.
7
Weak signal quality
Excellent signal quality

MANUAL TIME SETTING

If you are out of the reach of the Radio Controlled Transmitter
or if the reception is not reachable, the time can be set
manually. As soon as the transmitter is received again, the
clock will automatically synchronize with received time.
MSF/DCF Version:
1. In normal time mode, press and hold "TIME" key for 2
seconds until the Year digit flashes.
2. Press "UP" or "DOWN" key to change its value.
3. Press "TIME" key again, Month digit flashes, press
"UP" or "DOWN" key to change its value.
4. Repeat the above operation to set the time in this order:
Year > Month > Date > Hour > Minute > Second > Day
Language .
5. Press "TIME" key to save and exit the setting or let it exit
automatically 30 seconds later without pressing any
key.
WWVB Version:
1. In normal time mode, press and hold "TIME" key for 2
seconds until the Time zone map flashes.
2. Press "UP" or "DOWN" key to select the proper time
zone.
3. Press "TIME" key again, Year digit flashes, press "UP"
or "DOWN" key to change its value.
4. Repeat the above operation to set the time in this order:
Time zone map > Year > Month > Date > DST ON/OFF >
Hour > Minute > Second > Day Language.
8