Related Manuals for Technoline RADIO CONTROLLED PROJECTOR CLOCK
Summary of Contents for Technoline RADIO CONTROLLED PROJECTOR CLOCK
- Page 1 RADIO CONTROLLED PROJECTOR CLOCK User’s instructions P17018365A0173200E...
- Page 3 POWER The multifunctional clock is equipped with many functions providing thorough information to you. The receiver unit has Main unit: 4.5V, use 3 x AA 1.5V a clear, easy-to-read display that shows minimum/maxi- mum indoor and outdoor temperature, as well as time and Remote sensor: 3V, use 2 x AA 1.5V date.
-
Page 4: Remote Sensor
SPECIFICATION MAIN FEATURES: WEATHER STATION: MAIN UNIT Operating range: -5°C~50°C 23° F~122°F Resolution: 0.1°C/°F (above -10°C/32°F) 1°C/°F (below -10°C/32°F) Radio controlled signal: WWVB/DCF/MSF REMOTE SENSOR Operating range: -20°C~60°C ON OFF -4°F~140°F Resolution: 0.1°C/°F (above -10°C/32°F) 1°C/°F (below -10°C/32°F) 1. SNOOZE/LIGHT key: - Turn on the projector and backlight for 5 seconds. -
Page 5: Temperature Trend
TEMPERATURE TREND 4. TIME key: - Press it to switch between Month/Date and alarm time The temperature-trend indicator shows the trends of mode. changes in the forthcoming few minutes. Arrows indicate a - Press and hold it for 2 seconds to enter normal time rising, steady or falling trend. - Page 6 VIEWING THE CHANNEL 8. MAX/MIN key - Press it to check the minimum and maximum The default channel is Channel 1. In normal time mode, temperature records. press “UP” key to view the channels from 1 to 3. Besides, the channels can automatically switch by pressing and hold- 9.
- Page 7 17. RESET key NOTE: - Press it to reset all values to default values. - In case of malfunction, the unit may be required to reset. If no signals are received or the transmission is interfered, “—” will appear on the LCD. 18.
-
Page 8: Weather Station
5. BATTERY DOOR to turn on both ALM1 and ALM2, with the bell icons display on the LCD. Press it again to turn off both 6. WALL-MOUNTING HOLDER: ALM1 and ALM2, with the icons disappear. - Use it to support the transmitter on the wall. In ALM1/ALM2 mode, press alarm key once to turn on ALM1/ALM2, press it twice to turn on pre-alarm function, 7. - Page 9 Press “TIME” key to save and exit the setting or let it exit battery door and insert 3 x AA batteries into the battery automatically 30 seconds later without pressing any key. compartment. Make sure you insert the batteries the right way according to the polarity information marked ALARM AND SNOOZE SETTING on the battery compartment.
-
Page 10: Signal Strength Indicator
SIGNAL STRENGTH INDICATOR MANUAL TIME SETTING The signal indicator displays signal strength in 4 levels. If you are out of the reach of the Radio Controlled Transmitter Wave segment flashing means time signals are being or if the reception is not reachable, the time can be set received.
Need help?
Do you have a question about the RADIO CONTROLLED PROJECTOR CLOCK and is the answer not in the manual?
Questions and answers