Jam In Tray2 - Samsung CLP-600 Series Service Manual

Alignment and Adjustmens

6.2.7 Jam In Tray2

If paper i s j ammed i n the opti onal Tray2, a l amp turns on at the corresponding location on the Status
map. If you use the CLP-600N, "Jam0 In Tray2" also appears on the display.
1. Using the handle, completely open the access
door.
2. Open the top cover.
Service Manual
6-10
3. Holding the inner cover open, carefully take the
jammed paper out of the printer. The inner
cover will then close automatically.
If you cannot find the jammed paper, or if there
is any resistance removing the paper, stop
pulling and close the access door.
CAUTION:
• Do not touch the fuser inside the inner cover. It
is hot and could cause burns! The fuser's operat-
ing temperature is 180°C (356°F). Take care
when removing paper from the printer.
• Do not touch the green surface, the OPC drum,
on the front of each toner cartridge with your
hands or any other material. Use the handle on
each cartridge in order to avoid touching this
area.
• Be careful not to scratch the surface of the paper
transfer belt.
• If you leave the access door open for more than
a few minutes, the OPC drum can be exposed
to light. This will cause damage to the OPC
drum. Close the access door should the
installation need to be halted for any reason.
Samsung Electronics