Switching On / Start - Stop; Setting The Feed Pressure; Setting The Temperatures - Julabo FL1201 Operating Manual

7.4.

Switching on / Start - Stop

7.5.

Setting the feed pressure

7.6.

Setting the temperatures

Factory setting:
20
Switching on:
The recirculating cooler is turned on and off with the mains switch.
The unit performs a self-test. All segments of the 4-digit LED
temperature DISPLAY and all indicator lights will illuminate
(as illustrated on the left).
Then the software version and the type of unit is indicated.
Examples: (v 1.02) (FL1703)
The display "OFF" indicates the unit is ready to operate (standby
mode).
Press enter
Start:
The LED temperature DISPLAY indicates the actual bath
temperature.
Press enter
Stop:
Turn the unit off with the mains power switch.
Set the max. permissible feed pressure (example: 2 bar) by slowly
closing the adjusting valve (14) on the rear and looking at the
manometer (7).
max.
The max. pressure is determined by the weakest element in the
circuit (e. g. glass equipment).
25 °C
Setting can be carried out in the start/stop condition.
1. Press one of the keys
The setpoint value instead of the actual value is indicated on the
display for about 8 seconds.
The value can now be changed.
2. Change value:
Press
Press
Keep the keys depressed for the value to change fast.
3. Press enter
for about 4 seconds.
for about 4 seconds.
to set a higher value.
to set a lower value.
to store the value.
for a short moment.